cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3747
Views
5
Helpful
5
Replies

1542i Converting a CAWAP AP into a Mobility Express AP

r_m
Level 1
Level 1

Hello everyone
I followed the conversion procedure that I write below,

 

AP#ap-type mobility-express tftp://<TFTP Server IP>/<path to tar file>

 

with firmware : AIR-AP1540-K9-ME-8-7-102-0.tar

 

but the answer is as follows

 

############

Image transfer complete.
Image downloaded, writing to flash...
do CHECK_ME, part2 is active part
upgrade.sh: Error: image not found.
+ do_upgrade CHECK_ME
+ [ ! -r /tmp/part.tar ]
+ loudlog Error: image not found.
+ logger -p 0 -t upgrade Error: image not found.
+ echo upgrade.sh: Error: image not found.
upgrade.sh: Error: image not found.
+ return 1
+ status=1
+ set +x
Error: Image update failed.

##############

 

Has anyone had similar problems?

1 Accepted Solution

Accepted Solutions

r_m
Level 1
Level 1

Goodmorning everyone,
    the solution is to perform the conversion outside the class where the Controller Mobility Express is present and use the following command


ap-type mobility-express tftp: // <ip tftp server> / <path file .tar>

 

*** the error was just to perform the ap conversion in the same CME class.

 

once the following code is displayed

 

########################


Image transfer complete.
Image downloaded, writing to flash...
do CHECK_ME, part2 is active part
Image signing verify success.
AIR-AP1542I-E-K9
This is AP1542, use btldr_crete.bin.lzma/btldr_crete_md5 for uboot
Verify returns 0
Unlocking /dev/mtd4 ...
23+0 records in
23+0 records out
upgrade.sh: part to upgrade is part1
upgrade.sh: activate part1, set BOOT to part1
upgrade.sh: AP primary version: 8.7.102.0
Archive done.


#########################

 

restart the AP and move it to the class where the CME is present.

View solution in original post

5 Replies 5

I would try with other version 8.5.120.0 & see you face same issue ?

 

HTH

Rasika

Leo Laohoo
Hall of Fame
Hall of Fame

Alternatively, try this:  archive download-sw  tftp://<TFTP Server IP>/<path to tar file>

r_m
Level 1
Level 1

Goodmorning everyone,
    the solution is to perform the conversion outside the class where the Controller Mobility Express is present and use the following command


ap-type mobility-express tftp: // <ip tftp server> / <path file .tar>

 

*** the error was just to perform the ap conversion in the same CME class.

 

once the following code is displayed

 

########################


Image transfer complete.
Image downloaded, writing to flash...
do CHECK_ME, part2 is active part
Image signing verify success.
AIR-AP1542I-E-K9
This is AP1542, use btldr_crete.bin.lzma/btldr_crete_md5 for uboot
Verify returns 0
Unlocking /dev/mtd4 ...
23+0 records in
23+0 records out
upgrade.sh: part to upgrade is part1
upgrade.sh: activate part1, set BOOT to part1
upgrade.sh: AP primary version: 8.7.102.0
Archive done.


#########################

 

restart the AP and move it to the class where the CME is present.

Hi, when do you say the class do you referring to the network segment?

He definitely, does.

 

Review Cisco Networking for a $25 gift card