cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
219
Views
0
Helpful
0
Replies

1700 broadcast problem

erik bakke
Level 1
Level 1

Hi!

 

I have vWLC running on vmware.
2AP 1702i joined, but ​APs is not broadcasting at all
​interfaces is up, no error etc.. tested 8.0.120.0 and 8.1.121.0 release.

Broadcast ssid is on, wlan is enabled and ap and wlan in correct ap group. also tested default group

Controller and ap is connected to cisco 3560x in the same vlan

 

AP logs:

*Sep 25 10:58:53.263: %CAPWAP-5-SENDJOIN: sending Join Request to 192.168.25.2
*Sep 25 10:58:53.635: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Sep 25 10:58:53.643: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Sep 25 10:58:53.731: %CAPWAP-5-JOINEDCONTROLLER: AP has joined controller SHAWLC
*Sep 25 10:58:53.807: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Sep 25 10:58:54.515: %WIDS-6-ENABLED: IDS Signature is loaded and enabled
*Sep 25 10:58:54.635: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to down
*Sep 25 10:58:54.671: %LINK-6-UPDOWN: Interface Dot11Radio1, changed state to down
*Sep 25 10:58:54.679: %LINK-5-CHANGED: Interface Dot11Radio1, changed state to reset
*Sep 25 10:58:54.807: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio1, changed state to down
*Sep 25 10:58:55.663: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to up
*Sep 25 10:58:55.707: %DOT11-6-DFS_SCAN_START: DFS: Scanning frequency 5320 MHz for 60 seconds.
*Sep 25 10:58:55.711: %LINK-6-UPDOWN: Interface Dot11Radio1, changed state to up
*Sep 25 10:58:55.719: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Sep 25 10:58:55.727: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Sep 25 10:58:56.711: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio1, changed state to up
*Sep 25 10:58:56.719: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to down
*Sep 25 10:58:56.747: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Sep 25 10:58:57.747: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to up
*Sep 25 10:59:16.391: %CLEANAIR-6-STATE: Slot 0 disabled
*Sep 25 10:59:16.391: %CLEANAIR-6-STATE: Slot 1 disabled
*Sep 25 10:59:56.751: %DOT11-6-DFS_SCAN_COMPLETE: DFS scan complete on frequency 5320 MHz

 

 

 

 

Broadcast SSID
 Enabled

 

802.11a Network State

802.11b/g Network State
  

 

802.11a/n/ac Radios Detail
802.11b/g/n Radios Detail
Dual-Band Radios Detail

All APs

 Detail
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card