hello,
i get the problem my AIR-AP1832I-C-K9 , how can this problem solve please help me. please tell me details .
thanks you.
(RNAQ-C7) # reset
resetting ...
U-Boot 2012.07 (btldr release 38) (Oct 29 2019 - 06:39:45)
This product contains some software licensed under the
"GNU General Public License, version 2" provided with
ABSOLUTELY NO WARRANTY under the terms of
"GNU General Public License, version 2", available here:
http://www.gnu.org/licenses/old-licenses/gpl-2.0.html
DRAM: 1 GiB
NAND (ONFI): Detected SPANSION S34MS02G2 [256 MiB]
SF: Detected Macronix MX25U3235F [4 MiB]
MFG data loaded
Scanning shenv data blocks
Total valid parts=4
Active shenv part[1:1], write_counter=12
PCI0 Link Intialized
PCI1 Link Intialized
Net:
PHY ID = 0x4dd074, eth0 found AR8033 PHY
PHY ID = 0x4dd074, eth1 found AR8033 PHY
Valid I2C chip addresses: 51 52
AP 1832/1852 detected...
Power Type: 802.3at POE detected...
Signature returns 0
BL signing verification success, continue to run...
Auto boot mode, use bootipq directly
Hit ESC key to stop autoboot: 0
Specified BOOT: 2
UBI error: ubi_io_read: error -74 while reading 118784 bytes from PEB 1507:4096, read 28672 bytes
ubi_io_read[188] not here
UBI error: ubi_init: cannot attach mtd2
UBI error: ubi_init: UBI error: cannot initialize UBI, error -74
UBI init error 74
Booting from part1
Error, no UBI device/partition selected!
Error, no UBI device/partition selected!
Booting failed, try boot on part2
Error, no UBI device/partition selected!
Error, no UBI device/partition selected!
(RNAQ-C7) #
