12-11-2012 02:45 PM - edited 07-03-2021 11:12 PM
Although I have the 1mb data rate disabled on the controller I still see lots of 1mb traffic while performing a packet capture. How and why is this occurring
Thanks
Tom
12-11-2012 03:23 PM
1 MB seen from AP or client.
12-11-2012 03:26 PM
I just see lots of 1mb traffic in the wireless capture
12-11-2012 04:48 PM
which direction are you seeing - AP broadcast, AP to client, client broadcast or client to AP traffic.
can't control datarates for client, If 1 mb is disabled on AP that doesn't restrict the client sending traffic on 1mb.
12-11-2012 05:31 PM
Look at the MAC address in the 1 phy frames and see who the source and destination is.
Also why type and subtype are the 1 phy frames
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: