cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6746
Views
10
Helpful
17
Replies

2504 WLC with 8.5.140.0 version and AP1832i getting 54mbps only

wavelogix
Level 1
Level 1

I havre 2504 WLC with 8.5.140 image and AP1832i, in my Mac and Windows pc I am getting only 54mbps max. I have tried 40mhz and 80mhz as well but no improvement , any suggestions please

sathees

2 Accepted Solutions

Accepted Solutions

On the MAC recommend that you install: WIFI Signal

https://www.adriangranados.com/apps/wifisignal

 

Then post what SNR, RSSI and MCS you are getting.

 

As mentioned, can you share the config of the WLAN you are running.

*****Help out other by using the rating system and marking answered questions as "Answered"*****
*** Please rate helpful posts ***

View solution in original post

Thanks for the files.

Going back to Flavio's excellent question - Where are you seeing the stat that your client is connecting at 54 Mbps? Does the end device display it?

I would also make 54 supported as mandatory is a bit aggressive:

config 802.11a disable network
y
config 802.11a rate supported 54
config 802.11a enable network

Ric
-----------------------------
Please rate helpful / correct posts

View solution in original post

17 Replies 17

Ric Beeching
Level 7
Level 7

Can you perform a "show wlan X" where X is the number of WLAN you're using? Is it configured for WPA2-AES with WMM allowed?

 

-----------------------------
Please rate helpful / correct posts

Cisco Controller) >show wlan 1

 

 

WLAN Identifier.................................. 1

Profile Name..................................... sharikam

Network Name (SSID).............................. sharikam

Status........................................... Enabled

MAC Filtering.................................... Disabled

Broadcast SSID................................... Enabled

AAA Policy Override.............................. Disabled

Network Admission Control

Client Profiling Status

    Radius Profiling ............................ Disabled

     DHCP ....................................... Disabled

     HTTP ....................................... Disabled

    Local Profiling ............................. Disabled

     DHCP ....................................... Disabled

     HTTP ....................................... Disabled

  Radius-NAC State............................... Disabled

  SNMP-NAC State................................. Disabled

  Quarantine VLAN................................ 0

Maximum Clients Allowed.......................... Unlimited

Maximum number of Clients per AP Radio........... 200

 

--More-- or (q)uit

ATF Policy....................................... 0

Number of Active Clients......................... 2

Exclusionlist Timeout............................ 180 seconds

Session Timeout.................................. 86400 seconds

User Idle Timeout................................ Disabled

Sleep Client..................................... disable

Sleep Client Timeout............................. 720 minutes

User Idle Threshold.............................. 0 Bytes

NAS-identifier................................... none

CHD per WLAN..................................... Enabled

Webauth DHCP exclusion........................... Disabled

Interface........................................ management

Multicast Interface.............................. Not Configured

WLAN IPv4 ACL.................................... unconfigured

WLAN IPv6 ACL.................................... unconfigured

WLAN Layer2 ACL.................................. unconfigured

mDNS Status...................................... Disabled

mDNS Profile Name................................ default-mdns-profile

DHCP Server...................................... Default

DHCP Address Assignment Required................. Disabled

Static IP client tunneling....................... Disabled

Tunnel Profile................................... Unconfigured

Quality of Service............................... Silver

 

--More-- or (q)uit

Per-SSID Rate Limits............................. Upstream      Downstream

Average Data Rate................................   0             0

Average Realtime Data Rate.......................   0             0

Burst Data Rate..................................   0             0

Burst Realtime Data Rate.........................   0             0

Per-Client Rate Limits........................... Upstream      Downstream

Average Data Rate................................   0             0

Average Realtime Data Rate.......................   0             0

Burst Data Rate..................................   0             0

Burst Realtime Data Rate.........................   0             0

Scan Defer Priority.............................. 4,5,6

Scan Defer Time.................................. 100 milliseconds

WMM.............................................. Allowed

WMM UAPSD Compliant Client Support............... Disabled

Media Stream Multicast-direct.................... Disabled

CCX - AironetIe Support.......................... Enabled

CCX - Gratuitous ProbeResponse (GPR)............. Disabled

CCX - Diagnostics Channel Capability............. Disabled

Dot11-Phone Mode (7920).......................... Disabled

Wired Protocol................................... 802.1P (Tag=0)

Passive Client Feature........................... Disabled

Peer-to-Peer Blocking Action..................... Disabled

Radio Policy..................................... All

 

--More-- or (q)uit

DTIM period for 802.11a radio.................... 1

DTIM period for 802.11b radio.................... 1

Radius Servers

   Authentication................................ Global Servers

   Accounting.................................... Global Servers

      Interim Update............................. Enabled

      Interim Update Interval.................... 0

      Framed IPv6 Acct AVP ...................... Prefix

   Dynamic Interface............................. Disabled

   Dynamic Interface Priority.................... wlan

Local EAP Authentication......................... Disabled

Radius NAI-Realm................................. Disabled

Mu-Mimo.......................................... Enabled

Security

 

   802.11 Authentication:........................ Open System

   FT Support.................................... Adaptive

   Static WEP Keys............................... Disabled

   802.1X........................................ Disabled

   Wi-Fi Protected Access (WPA/WPA2)............. Enabled

      WPA (SSN IE)............................... Disabled

      WPA2 (RSN IE).............................. Enabled

         TKIP Cipher............................. Disabled

 

--More-- or (q)uit

         AES Cipher.............................. Enabled

         CCMP256 Cipher.......................... Disabled

         GCMP128 Cipher.......................... Disabled

         GCMP256 Cipher.......................... Disabled

      OSEN IE.................................... Disabled

      Auth Key Management

         802.1x.................................. Disabled

         PSK..................................... Enabled

         CCKM.................................... Disabled

         FT-1X(802.11r).......................... Disabled

         FT-PSK(802.11r)......................... Disabled

         PMF-1X(802.11w)......................... Disabled

         PMF-PSK(802.11w)........................ Disabled

         OSEN-1X................................. Disabled

         SUITEB-1X............................... Disabled

         SUITEB192-1X............................ Disabled

      FT Reassociation Timeout................... 20

      FT Over-The-DS mode........................ Enabled

      GTK Randomization.......................... Disabled

      SKC Cache Support.......................... Disabled

      CCKM TSF Tolerance......................... 1000

   Wi-Fi Direct policy configured................ Disabled

   EAP-Passthrough............................... Disabled

 

--More-- or (q)uit

   CKIP ......................................... Disabled

   Web Based Authentication...................... Disabled

   Web Authentication Timeout.................... 300

   Web-Passthrough............................... Disabled

   Mac-auth-server............................... 0.0.0.0

   Web-portal-server............................. 0.0.0.0

   Conditional Web Redirect...................... Disabled

   Splash-Page Web Redirect...................... Disabled

   Auto Anchor................................... Disabled

   FlexConnect Local Switching................... Disabled

   FlexConnect Central Association............... Disabled

   flexconnect Central Dhcp Flag................. Disabled

   flexconnect nat-pat Flag...................... Disabled

   flexconnect Dns Override Flag................. Disabled

   flexconnect PPPoE pass-through................ Disabled

   flexconnect local-switching IP-source-guar.... Disabled

   FlexConnect Vlan based Central Switching ..... Disabled

   FlexConnect Local Authentication.............. Disabled

   FlexConnect Learn IP Address.................. Enabled

   Client MFP.................................... Optional

   PMF........................................... Disabled

   PMF Association Comeback Time................. 1

   PMF SA Query RetryTimeout..................... 200

 

--More-- or (q)uit

   Tkip MIC Countermeasure Hold-down Timer....... 60

   Eap-params.................................... Disabled

AVC Visibilty.................................... Disabled

AVC Profile Name................................. None

Flow Monitor Name................................ None

Split Tunnel Configuration

    Split Tunnel................................. Disabled

Call Snooping.................................... Disabled

Roamed Call Re-Anchor Policy..................... Disabled

SIP CAC Fail Send-486-Busy Policy................ Enabled

SIP CAC Fail Send Dis-Association Policy......... Disabled

KTS based CAC Policy............................. Disabled

Assisted Roaming Prediction Optimization......... Disabled

802.11k Neighbor List............................ Enabled

802.11k Neighbor List Dual Band.................. Disabled

802.11v Directed Multicast Service............... Enabled

802.11v BSS Max Idle Service..................... Enabled

802.11v BSS Transition Service................... Enabled

802.11v BSS Transition Disassoc Imminent......... Disabled

802.11v BSS Transition Disassoc Timer............ 200

802.11v BSS Transition OpRoam Disassoc Timer..... 40

DMS DB is empty

Band Select...................................... Enabled

 

--More-- or (q)uit

Load Balancing................................... Disabled

Multicast Buffer................................. Disabled

Universal Ap Admin............................... Disabled

Broadcast Tagging................................ Disabled

 

 Mobility Anchor List

 WLAN ID     IP Address            Status                             Priority

 -------     ---------------       ------                             --------

 

802.11u........................................ Disabled

 

MSAP Services.................................. Disabled

 

Local Policy

----------------

Priority  Policy Name

--------  ---------------

 

QoS Fastlane Status.............................. Disable

Selective Reanchoring Status..................... Disable

On the MAC recommend that you install: WIFI Signal

https://www.adriangranados.com/apps/wifisignal

 

Then post what SNR, RSSI and MCS you are getting.

 

As mentioned, can you share the config of the WLAN you are running.

*****Help out other by using the rating system and marking answered questions as "Answered"*****
*** Please rate helpful posts ***

Client Statistics
Bytes Received
Bytes Sent
Packets Received
Packets Sent
Policy Errors
RSSI
SNR
Sample Time
Excessive Retries
Retries
Success Count
Fail Count
Tx Filtered
Data Retries
Rts Retries
Duplicates
Decrypt Failed
Mic Errors
Mic Missing Frames
RA Packets Dropped
Interim Updates sent
This page refreshes every 90 seconds

Hi,

 54 Mbps based on what?  It is an speedtest or something similar?  Or this is actually your air interface speed? Keep in mind that channel width is on variable on the equation.

 

 

-If I helped you somehow, please, rate it as useful.-

Has a site survey been conducted

From the CLI of the 2504 please share:

 

show wlan <ID>

debug client <mac address> - share the output of client connecting and disconnecting

 

Is the 54mbps the data rate being received? or the throughput of the client to speedtest.net?

what RF profiles do you have enabled. Is 802.11ac enabled?

 

What is the client device? is it an 802.11n or ac device?

 

 

*****Help out other by using the rating system and marking answered questions as "Answered"*****
*** Please rate helpful posts ***

please attached , not only 54mbps , its disconnects the clients specially iPhones , above I have attached the show wlan 1

 

chekc if you enable 802.11n or 802.11 ac rates.

 

Regards

Hi

I have enabled both radio's please see attached

Can you post a 'show 802.11a' and 'show 802.11b' from the CLI?

Also change your data rate to 20 MHz for now, disable the 802.11b completely and we can work up from there.


Ric

-----------------------------
Please rate helpful / correct posts

Hi Ric

 

I have moved to 20Mhz and disabled the 802.11b

Thanks for the files.

Going back to Flavio's excellent question - Where are you seeing the stat that your client is connecting at 54 Mbps? Does the end device display it?

I would also make 54 supported as mandatory is a bit aggressive:

config 802.11a disable network
y
config 802.11a rate supported 54
config 802.11a enable network

Ric
-----------------------------
Please rate helpful / correct posts

Ah, it's a cosmetic bug with the Macbook:

https://forums.macrumors.com/threads/imac-pro-wifi-issue.2099199/

Assuming your Internet speed is more than 54Mbit/s, what speed do you get on that same Macbook if you do a speedtest? www.speedtest.net

Thanks,
Ric
-----------------------------
Please rate helpful / correct posts

hi Ric, i have made the cadges as per your suggestion and download the app as per Hayden , the result is much better , but see I have replaced one AP with 2702E as well. will monitor and update

Review Cisco Networking for a $25 gift card