Solved: 2600/3600 access points with WCS

Eric Lindsey · ‎03-01-2013

Quick question. Is there a combination of code where you can have 2600s or 3600s with a 5508 controller and be running WCS? After you think about that how about adding in a 2710 location appliance. We have a site that we acquired with this setup and are having a hard time trying to migrate them over to our NCS /Wism/MSE type setup.

Sent from Cisco Technical Support iPhone App

Leo Laohoo · ‎03-01-2013

Is there a combination of code where you can have 2600s or 3600s with a 5508 controller and be running WCS?

Here's the thing ...

I've got WCS 7.0.23X.0 (can't remember the last bit) but I've got two WiSM-2 running v7.4.100.0 and I can run templates on them.

You can draw your own conclusions.

View solution in original post

Leo Laohoo · ‎03-01-2013

Is there a combination of code where you can have 2600s or 3600s with a 5508 controller and be running WCS?

Here's the thing ...

I've got WCS 7.0.23X.0 (can't remember the last bit) but I've got two WiSM-2 running v7.4.100.0 and I can run templates on them.

You can draw your own conclusions.