05-30-2003 05:00 AM - edited 07-04-2021 08:44 AM
I would appreciate help configuring a WLAN using 3 340AP's:
I intend to use one 340AP as the Root/Access Point.
I have not been able to successfully configure the two remaing 340's as CLIENTS. I have association with the client 340's, and using a crossover cat5E cable I have Lan lights on the Client PC and ethernet port of the Client 340, but no ethernet traffic. I have set all radios to static IP's in the range of our LAN, and they show in the association tables of the 340 access point, but there appears to be blocking at the ethernet ports?
Any hints will be appreciated!
Paul.
05-30-2003 05:40 AM
I'm not sure I understand your description, but I think what you need is the Workgroup Bridge.
06-01-2003 08:53 PM
Hi Paul,
Any of the AP's (340's 350's 1200's 1100's etc) can NOT do the toplogy
ethernet --AP ----wireless --AP--- ethernet
The ONLY way you can do this topolgy is either 2 BR350's or an AP and a WGB as long as there is less than 8 MAC addresses behind the WGB
The AP in client mode will simply associate to the root AP and is only intended as a tool for site survey to do a radio link test, it will NOT repeat radio traffic and will not pass traffic to the ethernet
In Repeater mode it will extend the range of the root AP buy repeating the signal on the radio side but will NOT pass any traffic on the ethernet port
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide