Wireless

Repeater limit: hops or leafs?Starting with the following configuration..AP Root ---- Rpt 1 ---- Rpt 2..I know that available throughput will be divided by two if we add one more repeater to Rpt 2Question: Is the effect the same when you add several ...

We have an Aironet 1200 Series Access Point that I am trying to set up for our shop employees. When I go into IPSU and enter the MAC address that is listed below the unit and click on get IP Address, it says device does not answer. Then, when I click...

I have one Access Point 340 connected to my Cisco 3550 Switchand I have another Cisco Work Group bridge connected to another switchwith 4 clients on it.I can communicate with access point from the hosts via workgroup bridgeonly if I have static IPs b...

We are using aironet 350's and want to know why different speeds are quoted as different distances, is it to do with quality or something? Thanks

I am trying to connect a BR352 multifunction bridge set up as a root bridge to computers with aironet 350 client adaptors over water at distances up to 9 miles.I have line of site and am using high gain antennas and amplifiers to RF attenuation shoul...

I am getting a client that is loosing association and I am given a specific error code of 8411. Anyone else have a idea what this code means? I have done a search on google, cisco and a couple other various search engines and found nothing on this is...

I used a new ap1200 with an 11.42 image on it and tried downloading an config file to it from a file taken from an ap1200 point with 12.00T image. I got the following message: 2097/01/10 01:01:01 (FATAL): Radio Enable Failed with error "BadAuthentica...

Can anybody please advise if they have managed to enable PEAP with SecurID authentication using ACS and a 3rd party PEAP supplicant such as Funk Odessey and Mtg House AEGIS Client.I am trying to integrate 3rd party cards to support: Strong Authentica...

What are the ramifications between having an antenna set to horizontal versus vertical?One of our techs set the 19 dbi sector antenna to horizontal. this seems to have given us about 160 degree coverage from a 90 degree sector antenna (was 90 degrees...

I have 802.11a implemented in a warehouse environment. 4 AP's total. about 25 clients. Unfortunately the equipment is not cisco but I'm looking for 'general' info that should apply to all 802.11a and I'm sure there are plenty of knowlegable people in...

I am setting up AP1200 and trunking 2 vlan and setup two SSID. This is what I wanted to do. Have one vlan and ssid that is not restricted, this SSID and would be broadcasted. People with out of the box confiured client would connect to this net get a...

I only have four clients to this access point, which I have hard coded the SSID on to them. I want to keep programs like NetStumbler from knowing the AP is there. I have WEP, TKIP, and MIC installed for security I just figure if you can keep someone ...

Is there any possibility to get more than 11Mbps of transmission speed over wireless bridge, .e.g binding 5 wireless bridges to get 55Mbps?Thanks.

I have a AP 350 series connected to a 826 ADSL router. I have no problem what so ever with my internetconnection because I used the same setup with a cable connected to the 826 and I didn't had the problem.My problem is that after 50 minutes or so my...