3504 wlc LAG

[eigrpy]

Hi we are going to lag interfaces on wlc3504. Based on gui of the wlc, we enabled the LAG and rebooted it. LAG means binding several ports together into one. My question is when I was trying to enable it, there was not chance to define which several ports are going to be bind into one interface among the available four ports. Do we need to define port that would need to be bound? Anyone can answer the question? Thanks

[balaji.bandi · Accepted solution]

LAG means binding several ports together into one

yes your understanding correct, you need to do other of the device also (like Switch to communicate)

here is some good explanation  with a diagram :

https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010100001.html

http://www.firewall.cx/cisco-technical-knowledgebase/cisco-wireless/1223-how-to-configure-wlc-lag-and-port-channel-with-nexus-catalyst-switches.html

[eigrpy]

Thank you! resolved.