3600 Series Access Point Problem

[rgoble]

Have a AIR-CT5508-K9 Controller running 7.0.116.0 software.

Just purchased 3 AIR-CAP3602I-A-K9 access points.

When these try to join the controller we receive the following error message.

%CAPWAP-3-UNSUPPORTED_WLC_VERSION: Unsupported version 7.0.116.0 on WLC Plt-72-Controller-1

Do the 3600's require a certain revision of code?

Also I read were the 3600's require a GE connection. Will they work on a FE connection?

Please advise.....................

[Stephen Rodriguez]

Yes, you need to be funning 7.2 code for the 3600 to join and work.

Make sure you check the release notes for hte supported AP, incase you are running any that are not supported in 7.2

Steve

[rgoble]

Thanks.....That is what I was afraid of.

[d-berlinski · Accepted solution]

I believe that version 7.1 also supports the 3600's and may support more of the older ones if that is an issue.

[rgoble]

Thanks I will  look at the release notes on this version of code.

[Stephen Rodriguez]

7.1 does, but for the full features of the 3600 to be used, you would need to be on 7.2, as it's the 'full' release.

Steve