3850 WLC: Enabling Access Points via CLI

[Heinz Schwarzfeuer]

Hi,

we have a couple of 2802 APs registered on a 3850 (16.3 Denali). 

Obviously the "Admin Status" of the APs must be set to "Enable" to put them into operation. I found it in the web gui (see attachment).


Does someone know how to do it via CLI?

Thanks!

[Rasika Nayanajith · Accepted solution]

Hi 

You can use below CLI command

3850#ap name <AP_Name> no shutdown 

An example shown below

3850-1#ap name 3702-2 no shutdown 

3850-1#sho ap config general | in Admin
Administrative State : Enabled

HTH

Rasika

*** Pls rate all useful responses ***

[Heinz Schwarzfeuer]

Hi Rasika,

that´s it! Thanks a lot!

Heinz