ā02-13-2020 07:46 AM - edited ā07-05-2021 11:42 AM
Hi
When I roam from one floor to another with my Staff Device while connected to Staff WiFi I am facing this issue.
Each floor access switch is configured different VLAN for STAFF WiFi , So when I roam from one floor to another I get different IP address from the VLAN subnet for that particular floor .
Well THE PROBLEM is when some users go to different floor they are not getting new IP address and getting error ( No internet connection ).
Couple of time users need to tern off and on WiFi on the device they after few minutes they get WiFi connection and new IP address.
While I checked log for that device on the Cisco ISE, I can see error as below.
WLC is Cisco 5520
AP is AIR-CAP2702I-E-K9
Please can some one advise how to solve this issue
""""Authentication Details
Policy Server LNZELSIME0-ISE-01
Event :5440 Endpoint abandoned EAP session and started new
Failure Reason :5440 Endpoint abandoned EAP session and started new
Resolution :Verify known NAD or supplicant issues and published bugs. Verify NAD and supplicant configuration.
Root cause :Endpoint started new authentication while previous is still in progress. Most probable that supplicant on that endpoint stopped conducting the previous authentication and started the new one. Closing the previous authentication.""""
Many thanks,
ā02-13-2020 08:25 AM
ā02-14-2020 06:19 AM
ā02-18-2020 02:51 AM
ā02-18-2020 03:42 AM
Hi Prkalavadia,
Which is the software version in your WLC?
Regards,
LeoC
ā02-18-2020 03:54 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide