Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
we have two android devices. One works but the other has problems.Same modell and same Andoid version 10Run cisco 9800-40 version 17.3.2.a , Using PSKOne android client does not change Ip address when it changes ssid on wlc01.If the client is on 19...
Hi, I would like to know if there is a way to have similar performances of a AIR-ANT2544V4M-R= antenna by using 4 dipoles AIR-ANT2524D-R. Thank you in advance
Resolved! MR-76 antennas
Hello guys,A partner of ours wants to buy several MR-76.Assuming that there is no obstacle, how many meters are their antennas range? 10-15 meters?I am talking about omni and directional: MA-ANT-20/21/23/25/27.Thanks a lot for your time.
Hello Everyone, Can anyone tell me how to capture traffic of cisco ISE 3.0 server in cacti 0.8 Monitoring Tool? i want to monitor total bandwidth being used by ISE server. Thanks.Shrijan
Hello,I have an existing WAP371(AP'S) Wifi cluster does anyone know if the WAP581(AP'S) is compatible with the WAP371 cluster.I looked around but can't seem to find an aswer. Thank you
Hello, I have a new incident I'm working on with a user who is telling me he has been getting bounced off of one particular SSID. He claims that others using Guest and another SSID are not losing connectivity. This user is on a Windows 10 laptop and ...
Resolved! MX in Concentrator Mode
Cisco WLC’s has a concept called “interface Group” whereby multiple vlan’s can be grouped and tied to single logical interface.A centrally switched SSID can then be configured to use an “interface Group” and the traffic for that SSID will be dropped ...
Hello, We have a WLC 5520 8.5.171.0 in flexconnect mode, with different APs model (in total 315 APs). In France, we have a site with 12 APs, mix of 3802E and 3802I. In 5Ghz, one 3802I AP has these power levels : Tx PowerNum Of Supported Power Levels ...
Hi guys,Can you help me with this?I want to create an SSID with Active Directory as authentication. I't says that I need to install Certificate Authority in the AD server and I already done that but still I get the same error. Error testing Active Di...
Hi all, I have just procured a 140AC at one of our remote office. It is has an RV345P installed which is convenient. The device is plugged in and configured with an IP address. I can VPN into the office, but I can contact the device, the port 22 and ...
Using 2x 1562's in this exact setup for bridging. I get to the part for whitelisting the MAC address (done), and enabling bridging (done) but the MAP never joins the RAP, with this error in the CLI: CRIT-MeshAwppAdj[1]: Blacklisting Adjacency due to ...
Buenos díasAdquirí un AIR-AP2802I, veo que mi VWLC lo detecta pero el mismo no publica los SSIDs configurados, en ese mismo VWLC tengo otros 18 AIR-AP2802I y los mismos si están publicando los SSIDs configurados. Les agradezco si pudieran guiarme, ya...
Resolved! Migrating from Cisco wireless to Meraki
Hi there,I have a customer who is running the cisco enterprise wireless solution (dual controllers in HA) in a Datacenter. They have around 400 AP's deployed across two main campus 13 branch locations. 3 x SSID's are centrally switched (CAPWAP tunnel...
Hi, AP capwap tunnel is lost to the WLC but on the switch the AP is reachable via ping. AP is Leighwight 2702i 15.3(3)JK5 and the WLC is 3504 8.10.151.0 (its compatible) Set up is: WLC > Aruba switch > APNote, other AP are connected to same switch b...
Resolved! Cisco wlc mac filtering.
Hi Gurus, Where can I check logs if a user cannot connect suddenly to a wifi with mac filtering? User can connect to this wifi 3 months ago. We use a server for mac database. For troubleshooting I did put a local mac filter to test it but the user st...
