About lecabral

lecabral · 04-11-2025

Hi,After migrating a 1572 from an AireOS controller to a 9800 running 17.12.3 we noticed that when opening the AP configuration page, we see all interfaces, 0 thru 4, in the Interfaces tab, but we only see interfaces 0 thru 3 under the Mesh tab, henc...

lecabral · 05-25-2024

Hi community,In our environment I have many 9k switches onboarded to DNA Center. I'm in the need to perform a config change to all of them, but I'm unclear on how to proceed. I'm used to utilize the Provision feature with templates, but I'm not sure ...

lecabral · 04-29-2024

Hi all,I'm configuring a 9200L switch to be a spare, just with its management interface Gi0/0 configured. It's up and running, and I can login using a local account. However radius is not working, it seems that the switch is unable to contact the rad...

lecabral · 04-26-2024

Hi,I wonder which is the best way to monitor our DNA Center appliance. We have all our networking infrastructure monitored and we want to have DNA Center also under this tool (from SolarWinds). We usually monitor using icmp and SNMP. Is it possible t...

PI API radius user · 03-14-2023

Hi,We have been using Prime 3.9 API with a local PI user (nbi_read) but we would like to use a radius user instead. I'm wondering if anyone knows if this is possible and a sample reply to receive from ISE, most likely ISE will need to return two role...

lecabral · 04-13-2025

This response was helpful, but should not be considered the solution.

lecabral · 04-13-2025

As I mentioned in the original post, the 1572 was migrated from an AireOS WLC to the 9800 WLC and the Gi4 configuration survived the migration somehow. Thanks all for your comments.

lecabral · 04-12-2025

Hi @marce1000 thank you for your suggestion. I tried it, but unfortunately, the CLI also ignores the existence of Gi4:myWLC#ap name my152AP mesh ethernet ? 0 Configures Ethernet Port 0 of the AP 1 Configures Ethernet Port 1 of the AP 2 Configures Eth...

lecabral · 03-11-2025

Is there any documented solution for this problem on 3.9? Thx.

lecabral · 07-29-2024

Hi! I'm in the same situation and I'd like to confirm if we're still in the state or if we can somehow check the AD-Host-Resolved-DNs value. We're using ISE 3.2 patch 6. Thx!

Member Since	‎04-05-2018 11:41 AM
Date Last Visited	‎05-12-2025 11:12 PM
Posts	31
Total Helpful Votes Received	2

User Statistics

User Activity

1572 not showing Gi4 in Mesh tab on 9800 WLC running 17.12.3

Best way to modify multiple switches across the DNA Center hierarchy

Access via Management Port with radius authentication

Monitoring of Catalyst/DNA Center itself

PI API radius user

Re: 1572 not showing Gi4 in Mesh tab on 9800 WLC running 17.12.3

Re: 1572 not showing Gi4 in Mesh tab on 9800 WLC running 17.12.3

Re: 1572 not showing Gi4 in Mesh tab on 9800 WLC running 17.12.3

Re: Cisco Prime 3.9 stuck on delete in progress for a controller v17.1

Re: Using AD-Host-Resolved-DNs in Profiling