I'm trying to configure SSO between two 5508. Everything is working almost excellent but when I'm trying change Mobility MAC to different one, I cannot do this :(.
After I configure mobility mac on both WLCs it's look like my new settings has been accepted by the software:
(WLC-LAB1) >show redundancy summary Redundancy Mode = SSO DISABLED Local State = ACTIVE Peer State = N/A Unit = Primary Unit ID = 70:CA:9B:C9:4E:20 Redundancy State = N/A Mobility MAC = 70:CA:9B:C9:20:20
but after I enable SSO new mobility MAC disappears and it's changing to the "Unit ID" MAC.
Can anyone please tell me what is going one? If this is a bug or I'm doing something wrong?
I upgraded the code to the version 8.1.x and I was able to configure different SSO mobility MAC then the Unit ID but it was only ones. After i disabled SSO to perform some other tests and I'm trying to configure SSO once again, I was not able to configure new mobility mac :( again.
I have no idea if there is any special configuration order or requirement to enable this feature with is relevant for me.
Thank you for the overwhelming response to the First and Second EFT refresh of 8.10MR6!
We are excited to announce the third refresh of 8.10 MR6 EFT Program for PRODUCTION deployments.
While the CCO release of 8.10MR6 is just a few we...
Greetings!Thank you for the overwhelming response and feedback for the first 17.3.4 EFT/Beta release.
Now we are excited to announce the second refresh of 17.3.4 EFT/Beta Program for PRODUCTION deployments.
This release is the s...
It’s been about two and half years, since the launch of next generation Cisco Catalyst 9800 Wireless LAN Controllers that has the most deployment flexibility and runs the modular, scalable, highly reliable, open and programmable operating system, I...
Hi All, I have made this video for Cisco Pitch the Future Contest in Malaysia which talks about Wi-Fi 6 and EWC Demo. Please feel free to view the video below and please support me for this contest by giving the video a like as the Contest will end o...