02-04-2013 03:58 PM - edited 07-03-2021 11:28 PM
I am configuring an 1142n. I am testing to make sure the 5GHz radio is functioning properly. When I disable the 2.4GHz radio, the SSID stops broadcasting. Is this expected behavior?
-Thanks
02-04-2013 04:09 PM
No its not... can you verify that your WLAN radio policy is set to all? Can you post your show wlan
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
02-05-2013 01:48 PM
Cisco 1142n
Image C1140-K9W7-M ver. 12.4(21a) JA1
There does not seem to be any show wlan command.
IGT-WAP-2#show run
Building configuration...
Current configuration : 1671 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname IGT-WAP-2
!
enable secret 5 $1$.9O/$j/hr.J6Ogv4y2Tgb6jlIh/
!
no aaa new-model
!
!
dot11 syslog
!
dot11 ssid IGT-Wireless-2
authentication open
authentication key-management wpa
guest-mode
wpa-psk ascii 7 143E353F1B0D382E282D202663
!
!
!
username Cisco password 7 05280F1C2243
!
!
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
ssid IGT-Wireless-2
!
antenna gain 0
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface Dot11Radio1
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
ssid IGT-Wireless-2
!
antenna gain 0
dfs band 3 block
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface GigabitEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
no keepalive
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 10.10.25.139 255.255.255.0
no ip route-cache
!
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
snmp-server community public RO
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
login local
!
end
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide