Wireless

I want to convert CAP-AIR 2600 access point to SAP but i can't connect to it via console ..it needs controller but i haven't.

Dear Friends,One of my client want to encrypt data over the wireless. I have cisco WLC 2504 IOS Version 7.2.0.0.Please help me on this. I think by-default data encrypt is enable. If not so how can I enable it. If I enable it is there any impact to my...

i want to ask if controller 2500 support t IPv4 & IPv6 .Shall deliver centralized security policies,wireless intrusion prevention system (IPS) capabilities,rogue access point indentification and containment,RF management,redundancy,QoS,and Layer 3 fa...

Hi,I wanted to ask if you can somehow disable / remove those clients that are in some way rejected by the wireless network, to avoid consuming system resources.for example on the wlc gui I can see many clients connected at the radio (because filtered...

Hi all,This is a lab system that I'm just building out- I try to see the obvious but it does bite me occasionally.  I have a 5508 WLC running release 7.4.1.  My AP's are all Cisco 3602E's with the AC modules.  My problem is that the Access points can...

hi, i have a WLC526-K9but it only boots the bootloader, and thats about it.i have tried the resetbutton, but i only get the secs showed that i have pressed the button, so im guessing that the software is gone from the controller, also because it 'boo...

My colleague made a change to the wireless environment and I'm trying to understand why we observed the unexpected behavior I will now describe.Prior to the change, the port configuration for all of our HQ-based WAPs was this: interface Gix/0/z  swit...

What is the maximum acceptable CPU Utilization percentage for a CISCO MWR 2941-DC router that is not prone to errors?

Hi,yesterday ive got my WAP561. I fidured out that he is not able to establish a Network Connection to my Netgear POE Switch (GS110TP). The Port stays down. So i tryed it with an POE Injector and an HP1810G Switch. Again no Link. Wenn i attach the Li...