881W wireless http config page shows only "Enter" button

[endpoint]

Hi,

I have new 881W router, the wired portion works like a charm, the wireless part not quite..

When using Cisco Config Pro to access wireless part of it. it suppose to open a browser so i can continue configuring wireless part. Unfortunately, when i click on Launch Wireless (or simillar), the browser opened the page and i have only button "Enter". When i click on it i got error on the page in bottom right corner of the IE, or nothing happened if i use Firefox.

Coudl someone shad some lights on this issue? I have been googling it and found some article about different IOS code for AP. That article did not apply to my case even dough symptoms were the same, downgrading to mentioned IOS version did not help.

Any suggestions appreciated.

Regards,

[pcroak]

Hi,

This is a known bug on the embedded AP on the 881W -- CSCtc94776. It occurs on software version 12.4(21a)JA1 -- what version of software is running on your AP?

The recommended resolution is to upgrade the AP module (not the router) to version 12.4(25d)JA1.

The image name is :

ap801-k9w7-tar.124-25d.JA1.tar

And you can initiate the upgrade from the AP CLI:

archive download-sw /force /over tftp:///

-Patrick Croak

Wireless TAC

[Surendra BG]

Hi,

Please check thje below doc written for the same by me..

https://supportforums.cisco.com/docs/DOC-13047

Regards

Surendra