9800-CL NO VLAN Setup

[chop249]

Hi all, 
I'm trying to setup a 9800CL without any vlan. I can set it up and get an IP while using vlan1 from my DHCP server but for some reason I cannot see NASes when I connect my MacBook to the AP connected to the 9800. I can connect to them if I go to Finder>Connect to Server and enter the smb:// address. I really don't care if I have vlan1 up and my network devices are populated, that would work too. I just have no need for vlans on this network so everything is on the same subnet.
Thanks!

[marce1000]

 

  - Your plan looks 'worry some' since already the device management and the Wireless Management Interface need a separate VLAN. You may always checkout all configuring attempts on the controller with the CLI command
 show tech wireless and feed the output from that into Wireless Config Analyzer

 M.

[Rich R]

Your problem is more likely to do with mDNS than VLANs...
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/technical-reference/c9800-best-practices.html#Multicast

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/215352-configure-and-troubleshoot-mdns-on-catal.html
https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/9800/17-3/deployment-guide/c9800-mDNS-technical-guide-rel-17-3.pdf
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-12/config-guide/b_wl_17_12_cg/m_mdns_gateway.html