AAA in Cisco Aironet

[haithamnofal]

Hi,

I have configured AAA for the CLI access to my Cisco aironet AP. However, for the HTTP access I am having some issues. I only can find the "ip http aaa" command for HTTP access but once configured it gives problems with the level of access as it always prompts me for Level 1 access instead of Level 15.

Can somebody help on how to configure Authentication/Autorization for HTTP access?

R/ Haitham

[irisrios]

The best way for http authentication is to carry it out from GUI rather than CLI which is found to have some problems. From GUI you can do this from Security - > Admin access fro AP 1242 series access point.

[Jagdeep Gambhir]

For HTTP you need to have prv lvl 15. Anything less then it is not going to work.

Regards,

~JG