02-06-2011 01:05 AM - edited 07-03-2021 07:46 PM
Hi
Can any one guide me in the right direction. I need to create a wireless profile that only allow internet access to who connected to that pofile
regards
Isaac
02-06-2011 01:14 AM
Hi Isaac,
Here is the link which tells us the way to do it..
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml
However, your question is more of a Routing configuration on the L3 device and has nothing to do with Wireless if your Wireless configurations are already done.
Please let me know if you need any wireless config help and we will help you in the WIreless forum.. if not please post the same question in Routing Forum in the Community and you will get the right resource..
lemme know if this answered your question..
Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull
02-06-2011 06:08 PM
Sur is on target with this response. 5 stars bud
If I could add. Having used ACLs extensivily myself, I would not use an ACL on the contoller if you have a large deployment. Put it on the wired side, if you go teh ACL route.
09-03-2011 05:36 AM
Hello Isaac,
Please mark the Question as Answered, if the provided information by Surendra and George is correct and it helped. By doing that others can take benefit as well.
Thanks,
Vinay Sharma
Community Manager – Wireless
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide