Access Point AIR-CAP3702I-A-K9 to autonomous

[csocorro1]

Is it possible to convert the access point AIR-CAP3702I-A-K9 to autonomous, and in case it is, how do I convert it?

Thank you

[Leo Laohoo]

Read THIS.

[csocorro1]

Thank you for your short response Leo.

The problem is that I tried to do it with a TFTP server but wasnt able to establish connection between my pc and the AP.

I've converted APs before, but never an air-CAP3702i-a-k9.

I will try to convert but havent been succesful so far.

Thanks again

[Leo Laohoo]

The problem is that I tried to do it with a TFTP server but wasnt able to establish connection between my pc and the AP.

What error messages are you getting?  Is the PC firewall turned off?

[csocorro1]

The firewall is off.

I'm using 3CDaemon and the message that I get is that it cant open the file.

I tried using the following filenames: ap3g2-k9w7-tar.default and ap3g2-k9w7-tar.153-3.JC by CLI in the WLC.

Do you know what can I be doing wrong or another walkaround for this issue?

[Leo Laohoo]

I'm using 3CDaemon and the message that I get is that it cant open the file.

Are you sure this is the error message?  

Run the entire proceedure again and post the entire process.  I want to see everything, including the error message. 

[csocorro1]

Attached is the capture in the TFTP Server.

I then tried the second method (Using MODE Button and TFTP Server) and still couldnt do it. In this case, the problem was the following:

IOS Bootloader - Starting system.
flash is writable
Tide XL MB - 40MB of flash
Xmodem file system is available.
flashfs[0]: 68 files, 9 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 41158656
flashfs[0]: Bytes used: 20953600
flashfs[0]: Bytes available: 20205056
flashfs[0]: flashfs fsck took 11 seconds.
Base Ethernet MAC address: 00:42:68:18:22:30
Ethernet speed is 1000 Mb - FULL Duplex
button is pressed, wait for button to be released...
button pressed for 24 seconds
process_config_recovery: set IP address and config to default 10.0.0.1
process_config_recovery: image recovery
image_recovery: Download default IOS tar image tftp://255.255.255.255/ap3g2-k9w7-tar.default

examining image...
DPAA Set for Independent Mode
tide_boot_speed = 1000
DPAA_INIT = 0x0

%Error opening tftp://255.255.255.255/ap3g2-k9w7-tar.default (permission denied)ap:

What do you think that can be wrong?

[Leo Laohoo]

permission denied

"permission denied". That says a lot. Check the "permission" of the file. 

If not, try using another computer to be the TFTP server.

[csocorro1]

Do you think the problem is the TFTP Server or the computer?

Thank you

[Leo Laohoo]

I am suspecting the computer is the problem.