10-27-2016 06:20 AM - edited 07-05-2021 06:03 AM
Hi all I hope you can help me I have a faulty Cisco AIR-LAP1143N-E-K9 wireless access point that I got second hand and I was wondering if there is any way to fix it before I try to send it back.
When I first start the AP I hold in the mode button until it turns red then when it has finished booting I use the reset command (I have done this to over 20 AP’s recently all worked fine) but this access point just loops constantly and never appears in the admin interface.
I have attached the full log of what happens when viewing in putty.
Any information you can give me will be very much appreciated.
Regards,
John
10-27-2016 06:17 PM
11-03-2016 09:04 AM
Hi Brett
Thanks for the reply will try this very much appreciated.
Regards,
John
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide