Wireless

Hello all,   Setup : 3504 WLC HA-pair, 8.5.140 and 2802i Access points   This is a new setup and after configuring the WLC and adding the APs, a handful APs did not join due to cabling problems. After these problems were resolved the APs tried to joi...

I have several LAP currently not available to load the flash.. error loading.....  so i boot it up using the recovery mode and flashed several IOS in the flash dir. all of them are not functioning and fail to load.  the problem is, how to delete the ...

Testing SNMP Walk to WLC of MIB File "AIRESPACE-WIRELESS-MIB.mib". For my questions: 1. When Client_Uptime will be reset? For example, authen disconnect. 2. When ul_bytes and dw_bytes will be reset? 3. How does ul_bytes (1.3.6.1.4.1.14179.2.1.6.1.2),...

HiAn AP's signal is week, so i added one extender. I got two signals using inSSIDer. Please see attached picture. The upper picture shows the extender's signal strength -35 dBm and its Max rate 144 Mpbs. The low picture shows the AP's signal strength...

Hello Experts,    As per the CMX 10 ordering and licensing guide, the max number of APs and tracked MACs per day from the flagship MSE 3375 is 1000 Aps and 10,000 MACs per day.  However for the large scale deployments for campuses running on over 500...

We have spun up a CMX 10.5 server.  We tried to restore a backup of the old 10.4 server but it failed. So I connected the new 10.5 server to Cisco Prime and everything worked except licenses.   I tried to backup just the licenses on the 10.4 server b...

I have 6 x MR42s in a double storey building. They are connected to 3 x MS-120 switches which in turn connected to MX-84. All ethernet clients are getting the correct VLANs and their respectively DHCP-allocated IP addresses (from MX84 or on VLAN/subn...

Good day and thx in advance for any help.I 'm administration an Aironet 1242ag, and we are currently buying an AIR-ANT1728 as antenna. The standard cable for the antenna is 0.9m long, and It could be insufficient for my needs. So a few questions:Can ...

Hello.  I have a WLC running code 8.3.140 and has four SNMPv3 usernames configured.  Two of those SNMPv3 usernames I'm sure are used, but the other two I'm unsure of.  Is there somewhere via the GUI or CLI I can verify statistics or determine if a SN...

Hi everyone， i know 802.11r is a ieee standard，and it is used to fast transition.I have a issue about what clients can support it. I can find the apple device can support it after ios 6. I did not find any info about Windows and Android，and whether a...

Hi everyone, We only use IPv4 addresses at present for wifi clients, but occasionally we see clients register on the controller with IPv6 Link Local addresses. IPv6 is disabled on the controller (an 8510 with 8.0.140.0). Associating with an IPv6 addr...

I have a location with a 5508 wireless controller and many 3502, 3602 and 3702 wireless access points.  All of our access points use vlan 2, so I include the command SWITCHPORT ACCESS VLAN 2 on any port connected to an access point.  All of this has ...