Access point is not shown in WLC

[rakesh4]

My problem is Access point is not showing in Cisco Wireless controller. From Cisco Wireless Controller. I am pinging to access point IP address &my router IP Access point getting the IP also. I am creating the SSID In Cisco Wireless controller. Below is the my configuration

[Leo Laohoo]

Console into the AP and reboot the AP. 

Post the entire boot-up process.

[Sandeep Choudhary · Accepted solution]

also paste the output of these commands:

sh sysinfo from wlc

sh version form AP

Regards

Dont forget to rate helpful posts

[rakesh4]

I am already post the Wireless controller ,switch details.please check once

[Sandeep Choudhary · Accepted solution]

Mere bhai..thats is not complete info what we require.

Paste the output of this comamnd form AP console: sh version 

and also paste the complete bootup process from AP console.

which AP model you have ?

Regards

Dont forget to rate helpful posts

[rakesh4]

I am post details below

But I am forget the username and password

In boot up process it shows the IP address.

[Sandeep Choudhary · Accepted solution]

set corerct time on WLC and try again.

Command > Set time from WLC GUI

Regards

Dont forget to rate helpful posts

[rakesh4]

Not Getting Friend

help me please

[Leo Laohoo · Accepted solution]

AP has the wrong Regulatory Domain.

[Sandeep Choudhary · Accepted solution]

Leo is spot on..

you have a regulatrory mismatch...

For india you need to buy the corerct AP with right Indian domain.

Regards

[rakesh4]

previous days it is working fine,but now it is not working and why friends

[Sandeep Choudhary · Accepted solution]

You have two ways:

Did you correct the date/time on WLC ?

Either chnage AP model or chnage the country code on WLC (Which i dont recommand and its againest the law).

So better you should change AP otherwise it will join but only 2.4 GHz radios will be enabled.

Regards

Dont forget to rate helpful posts

[rakesh4]

Thanks Leo and Sandeep. It working after changing time on WLC but as you siad only 2.4 Ghz is UP.

Thanks again

[Sandeep Choudhary · Accepted solution]

Glad It worked. 

Thanks for rating

Regards

[anupandit]

where should we copy those outputs?