09-21-2013 03:46 AM - edited 07-04-2021 12:54 AM
one of access points has become faulty.
It is air-lap113ag-e-k9
The system does not have MAC address yet
The following commands will set MAC address,
parameters used by TFTP operation, and finish
loading the operating system software:
set MAC_ADDR
set_param
ether_init
tftp_init
boot
Tried to do set MAC_ADDR, with no luck.
How will i be able to recover this one.
Thanks
09-21-2013 07:00 AM
The ap should have a MAC address unless it is faulty. You shouldn't have to enter that info. Is the issue that the ap is booting into ROMMON mode? Do you see an error when you boot up the AP. What does the dir show and also the set?
Sent from Cisco Technical Support iPad App
09-21-2013 07:49 AM
HI Scott;
Thanks for you support.
This is the first thing i see
Xmodem file system is available.
flashfs[0]: 48 files, 14 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 15998976
flashfs[0]: Bytes used: 12607488
flashfs[0]: Bytes available: 3391488
flashfs[0]: flashfs fsck took 39 seconds.
Invalid parameter block -- no mac address available.
Unable to figure out local mac address.
The system does not have MAC address yet
The following commands will set MAC address,
parameters used by TFTP operation, and finish
loading the operating system software:
set MAC_ADDR
set_param
ether_init
tftp_init
boot
ap: dir
List of filesystems currently registered:
flash[0]: (read-write)
xmodem[1]: (read-only)
null[2]: (read-write)
ap: set?
Unknown cmd: set?
ap: set ?
ap:
Regards,
Nabil
09-21-2013 07:55 AM
That doesn't look good. You might just have to RMA that AP.
Sent from Cisco Technical Support iPad App
09-21-2013 08:03 AM
That is what i though as well. just done its days, and gone dead:-(
Thanks
Rgds
Nabil
09-21-2013 08:26 AM
Yeah... at least it lived for a while:)
Sent from Cisco Technical Support iPad App
09-21-2013 08:31 AM
ooh yahh
looking on the bright side:-)
Regards,
Nabil
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide