Access points joining different WLC

[karthikeyan gopinathan]

hi

i have a wireless controller module( NME-AIR-WLC25-K9) installed in a Cisco 2851 ISR, this setup is in my remote site, we are connected through MAN network. In our main office i have a cisco 4402 wireless controller. so whenever i install a AP in my remote site instead of joiining the remote site WLC, the access point joins my main office 4402 controller, i dont why it is happening, the AP is not even trying to join the remote site WLC.. i have not configured high availability and both these controller are in separate RF network.

the firmware version in NME-AIR-WLC25-K9 is 7.0.98.0 ...

the version in the other controller is 6.0.196.0

Please let me know what is else i need to check asap

Thanks

karthik

[karthikeyan gopinathan]

I created a template and pushed to the Access points which were joined different controller to join their appropriate local controller. I cannot create a case because we don’t have current support contract on it

[karthikeyan gopinathan]

Hi

I went to WCS and there was an option for AP configuration template, so through that I created a new template to forcefully join the primary controller and pushed it to the APs which have not joined the local controller. And it worked so perfectly. Thanks to you for your suggestions.

[Leo Laohoo]

i have not configured high availability and both these controller are in separate RF network.

Configure high availability will allow you to instruct the AP to join the WLC of your choice.  Let us know if you are running 4.X because this process needs to be done using CLI only.

[karthikeyan gopinathan]

It is not running 4.x it is running the new version 5.x

The upgrade was done so that they can support 1142n Access points