Wireless

HiI know that if i upgrade to firmware version 1.3.3 i can't downgrade to a lower version.But I'd like to know if possible to downgrade from 1.3.4SR1 to firmware 1.3.3 because  i'd like to test version 1.3.4SR1.ThanksBest RegardsMC

I recently upgraded from WLC 4.2.207.0 to 6.0.199.0 (WiSM), and WCS 5.2.130.0 to 6.0.196.0. All my heatmaps that contain 1231G LAPs are solid "maroon" (-35 dBm) in color. If I remove the 1231 APs from the heatmap selection on the right hand side, my ...

Hello,in last few days, the 1140 Series APs (802.11n) have disappeared from the maps of my WLSE. Previously appeared in red because the radio (802.11n) is not managed by the WLSE (version 2.15).APs now appear in gray colour in right menu: all locatio...

We have a 1131AG configured withWPA2 - AES and we would also like to allow only certian MAC addresses to attach.I found that MAC Authenication doesn't work with WPA.  Is there a way to configure MAC filtering instead?

What is the largest suggested broadcast domain that can be used in a wireless lan using 6509's with wism controllers? We are a university and we have issues with students pulling ip's with their mobile devices because their wireless is turned on thus...

Am currently looking for some wireless Cisco product that will be able to transmit data for the distance of 10KM.Do you think the Aironet 1410 will be able to do the job?Thanks

Hi,I'm doing a demo for a customer and I have a small "bug" on my WCS. The WCS is showing fault information on the home page. It says: "Total APs not yet assigned to Maps : 2". When I open the link, it says "None detected". There are also two unknown...

Has anyone managed to get wireless client authentication working with ACS using LDAP to Novell e-directory?  Having issues finding any solid documentation that proves it works.Thanks.

My wireless controller 4402 is running with 802.11a/n and 802.11b/g/n.  How do I disable 802.11a, 802.11b, 802.11n and keep the 802.11g?Thanks.

New commands were added to 6500 IOS SXF6 to ease initial setup of the trunk and channel ports for the wism. Problem is after typing these commands I can't undo them. This is the "wism module <mod> controller 1 native-vlan" command.After removing thes...

We are currently having an issue with clients that connect wireless and go to the web.  Our WiFi adapters on XP choose 1500 mtu by default.  when being tunneled it causes the packets to fragment and the pages to take forever to load.  At 1300 mtu, ev...

Hello,I have WCS running at the version 6.0.132; would like to upgrade to latest version 6 available; downloaded software and started installation. At the point where installation should find the previous version, the messages says that there is none...