cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
573
Views
3
Helpful
4
Replies
Highlighted
Beginner

Air Ant2440 and Air Ant5160

Hi,

I have this doubt I can connect the antennas AIR-ANT2440NV-R= and AIR-ANT5160NP-R= in the access points 1262.

Thanks

4 REPLIES 4
Highlighted

Both antenna are for indoor AP with RP-TNC connectors. So they should work on the 1262.

http://www.cisco.com/en/US/prod/collateral/wireless/ps7183/ps469/data_sheet_ant5160np.pdf

http://www.cisco.com/en/US/prod/collateral/wireless/ps7183/ps469/data_sheet_ant2440nv.pdf

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Highlighted

Ok, thank Stephen Rodriguez.

I had saw those data sheets, but I am not sure.

Highlighted

Something additional to add, Cisco will only support antennas up to 7dBi on the 1260. Anything higher will cause the AP to be out of spec for FCC.

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________
Highlighted

Here is my 2¢

Since these AP's have 6 ports, 3 on each radio, why not use an antenna like this:

http://www.tessco.com/products/displayProductInfo.do?sku=354980

Or if the ceiling isn't so high, something like this:

AIR-ANT2451NV-R=

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***