Wireless

I have been trying to find documentation describing above migration scenario, but have not found anything. Has anybody tried above migration?In the existing setup I have a MSE 3350 running ver 7.2.103.0 (with CAS 7.2.1.36 and Partner engine 4.4.2.7))...

Dear Community Members,Actually the the AP am working on is :AIR-CAP3502E-E-K9  to be connected to Cisco 2960 POE Switch.1. what configuration do i need on the Switch and AP LAN Port to Power the AP from the POE Switch Port.2. Do i need to associate ...

Hi all,I have Build a 5508-HA Cluster (7.4.100.0) , hat to reboot this cluster due to Licens install.After the reboot atleast one of the SSIDs was not broadcasting anymore, even the checkbox was checked.What did I do:Installed the Licenses @ Freiday ...

Hi We have cisco 2504 controller and 1200 series access point.These are in India and country code is IN.When access point joins the controller , then in wireless>advanced , i see the two country code is already configured these are Sri Lnaka(LK) and ...

Where and how do I store new IOS for a WISM-2 on the NCS.  I have the NCS set up to be the tftp server for a software download to the WLC but I  can't find documentation insrtucting me on how to store it on the NCS.  The old WCS was a Windows server ...

Since few days the WLC 2100 series controller and 3x LAP1131AG are getting disconnected and the controller gets offline via the local ip address.  At that point I have to reboot. To get anywhere and after I connect wirelessly to the AP before I know ...

Can i run both 2.4 and 5ghz at the same time? so my N user's can connect at 300Mpbs on the 5ghz bonded, and my G users can connect to 54Mbps?Also i ask because of coverage, my 5ghz does not cover as far as the 2.4 so those at the extremity's could at...

I've been using Aironet 1140 series access point for a while. Recently it started to drop the wireless clients quite often. we have nearly 20 wireless users and one access point. they are mix of apple macs, windows and mobile phone users. when i went...

I am seeing around 40mbps with the bridges showing m21 data rates with a clean 5GHz channel.  This is testing to a server on a 2960s (gig connections) to a 3600brdige  wireless over to a non-root 3600bridge  wired to an i3010 switch (fast E 100mbps) ...

Hi,is it possible to play an beep or something else on the 7921/7925 if the phone is leaving the wireless service are?RegardsPaul

Hello.I'm having this wierd problem with an IP phone behind a WGB. The setup is like this:Cisco controller -> Switch -> switch -> AP (Air LAP1142) -> WGB (Air LAP 1262) -> switch -> IP phone.The phone works, sometimes. Sometime for days, sometime for...