AIR-CAP1602i-E-K9

[al_the_al]

Hi,

i have recently bought a AIR-CAP1602i-E-K9 and a AIR-SAP1602i-E-K9. I could connect to controller with serial but login and password don't match (admin/admin). I could not connect to it by web (routeur DHCP on the lan), IP change very quickly.

I don't know what to do.

I have no wireless lan for moment and i want to build a little one with them.

[Leo Laohoo]

Username/Password:  Cisco/Cisco

[al_the_al]

ok, thanks, i could enter with this login/password.

I want to assign an IP to the controller now but i not really good with cisco
Could you tell me the instructions so that i could configure it with werb interface

thanks

[Amjad Abdullah]

Hi,

Please rate useful replies. Also, mark correct answers as "answered".

Check here about the initial config wizard:

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_gettingstarted.html#wp1189034

Regards,

Amjad

Rating useful replies is more useful than saying "Thank you"

[Leo Laohoo]

AIR-CAP1602i-E-K9

If you want to use the APs as autonomous, you'll need to convert this one from controller-based IOS to autonomous IOS.

[al_the_al]

yes but i can't go on the web interface for moment. Ip always renew

[Leo Laohoo]

Using a TFTP Server to Return to a Previous Release