Hello, We are currently in the process of migrating from WiSM to WiSM-2. We have a Guest SSID Anchored with 4400 WLC. Previously on WiSM, we had QOS profile configured with a limited bandwidth and it was working fine up and down stream. After mig...
Hello, We are currently in the process of migrating from WiSM to WiSM-2. We have a Guest SSID Anchored with 4400 WLC. Previously on WiSM, we had QOS profile configured with a limited bandwidth and it was working fine up and down stream. After mig...
hello, I attached to this email architecture to deploy. the rukus radio link is operational, and the AP in 1552 that is connected in this building is saved on my WLC. I change its role to MeshAP RootAP. I enabled ETHERNET BRIGHING. But other AP 1552n...
Hi, we've created a SSID, which is not being broadcasted. Now I would need to enable broadcast of the SSID-so my question is: how will the access points act after enabling it? Will they reboot automatically?? Or do they even need to be rebooted? Than...
Hi AllI'm working on getting internal WebAuth to work on a FlexConnect local switched SSID. From what I've been reading, it's possible but apparently not very straight forward. FlexConnect AP - if the SSID isn't local switch, WebAuth of course works ...
Will enabling CCKM on an SSID currently configured for just 802.1x authentication reset the AP's associated with that SSID in any way?
Hi,Is there a command to power cycle/reset ALL LWAP's on a controller at the same time? I see there is the reset command on the CLI but this is for specific AP's & not all AP's simultaneously.(Cisco Controller) config>ap reset ? <Cisco ...
We are seeing an issue with an ipad connecting to a WLAN configured for EAP-TLS using ISE 1.2, getting disconnected. The ipad will hop top another SSID. It will connect back to the other ssid when selected. Any ideas? I have a debug client for whe...
Hi guys, My company recently bought a new ap 1600 series which is not supported with the version i was using on my controller and i need to upgrade it to the latest version.We've requested for the latest version and our supplier send as two files "St...
I have Cisco 3602 APs, a 5508 controller, and NCS. I would like to view the client count and client traffic on a particular AP in real time. I know I can view the periodic numbers that NCS pulls but I'd like to see them any time I want. Is that possi...
Hello,I'd like to know if we can encounter problem by mixing different AP models on the same floor; As a client will roam between them and see two different APs capabilities, will he achieve fast and seamless roaming? I mean without disruption especi...
Guys, I have a question regarding LAG ports. From Rajan's post here https://supportforums.cisco.com/document/81681/lag-link-aggregation he mentioned the following: When you enable LAG, all ports participate in LAG by default. Therefore, you must conf...
Hello,I recently upgraded WiSM2 controllers to the 7.2 release and have found that quite a few Accounting Start and Stop packets arrive at the RADIUS server without the Framed-IP-Address.. We use it to login the wireless user into SCE so they are not...
I have some 1130AG (autonomous ) AP's that are working fine.But clients connected to one of them recently starts to have extremally poor connection quality.As channel (1) being used is occupied - decided to change to 6 - after that change (and only t...
When I added to AP to the WLC i checked AP Mode Bridge. I recieve the following error message "Please change the 80211a channel and TxPower assignment method from GLOBAL to CUSTOMwireless->Access points->Radios->802.11a/n->Configure" I am able ...
I would like to use a Cisco AP1262 in a mobile command vehicle to bridge to any WiFi Access Point that I know the SSID and Pasword to. Will the 1262 Bridge to a Non-Cisco Access Point?If so, any assistance in finding an example configuration would b...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 10-15-2026 05:58 PM | ||
| 10-12-2026 06:46 PM | ||
| 09-30-2026 07:34 AM | ||
| 08-10-2026 11:32 AM | ||
| 08-06-2026 09:29 PM |
| User | Count |
|---|---|
| 5 | |
| 2 | |
| 2 | |
| 1 | |
| 1 |