01-07-2014 09:30 PM - edited 07-04-2021 11:54 PM
Hi Experts,
After I read some documentation it is still not 100% clear for me what are the procedure to configure additional WLC controller we bought (
AIR-CT2504-HA-K9). What we need to achieve is just the basic N+1 redundancy. We have our existing WLC 2504 and 15 LAPs 1262.
Please advise if these steps are correct:
1. Backup existing config from primary WLC.
2. Upgrade backup WLC to the same OS version
3. Upload config to the backup WLC
4. Change all IPs - it should be different but on the same subnet as the primary one.
5. On the primary controller change AP redundancy settings - add IP of the backup controller.
6. Plug backup controller to the network and test failover by disconnecting the primary one from the network - after 2 minutes all APs should reconnect to the backup one.
7. If all good disconnect backup one from the network and all APs should fall back to the primary one.
Thanks in advance.
Regards,
Gleb.
Solved! Go to Solution.
01-07-2014 11:15 PM
Theses steps are fine, but you also need to not just change the IP address but the hostnames. Here is a guide for N+1 which walks you the configuration steps.
http://www.cisco.com/en/US/docs/wireless/technology/hi_avail/N1_High_Availability_Deployment_Guide.pdf
Sent from Cisco Technical Support iPhone App
01-07-2014 11:15 PM
Theses steps are fine, but you also need to not just change the IP address but the hostnames. Here is a guide for N+1 which walks you the configuration steps.
http://www.cisco.com/en/US/docs/wireless/technology/hi_avail/N1_High_Availability_Deployment_Guide.pdf
Sent from Cisco Technical Support iPhone App
01-07-2014 11:25 PM
Thanks for this Scott,
additionally do I always need to update the config on the backup manually as long as there are some changes on the primary one?
not sure what this means as well, do I need to go through this step (figure 2.8):
An HA-SKU secondary controller can also be used as a primary, secondary, or tertiary controller. This
can be configured under the AP specific configuration.
Thanks in advance.
01-08-2014 06:09 AM
The N+1 solution doesn't do any sort if sync like AP SSO which is available on the 5508's and higher end models. N+1 is basically like another WLC with license. You have to make changes to both. With Prime infrastructure, you can manage multiple wlc's, but if it's just two wlc's, it might not be something you really need.
Sent from Cisco Technical Support iPhone App
07-03-2018 03:39 AM
Hi,
if I understood it well:
Can I install a ct2504ha without buying licenses for it?
Does this inherit the licenses of the main ct2504?
Thanks in advanced
07-03-2018 03:43 AM
Hi,
Can I install a ct2504ha without buying licenses for it? Secondry WLC doent need any AP license. You just need to enable it by using the command on 2nd WLC "
config redundancy unit secondary
"
Does this inherit the licenses of the main ct2504? NO it will not. But still it will support max 75 APs (max for 90 days)
Here is the imlementation guide: https://rscciew.wordpress.com/2014/06/07/n1-high-availability-configuration-on-cisco-2504wlc/
Regards
Dont forget to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide