AIR-LAP1242AG-E-K9 route to ethernet port

[Titus1963]

Hello,

i have several 1242AG-E-K9 with 5Ghz and 2,4GHz radio and standalone firmware.

5Ghz radio2 is configured as repeater for connecting to the bridge and my local LAN and Internet.

2,4GHz radio1 is configured as access point for connecting wireless clients to my local LAN via radio2.

All is working well, but if i connect a client to the ethernet port of the 1242AG i can connect the 1242AG itself, but not my local LAN and internet.

Is there a possibility to configure a route from the ethernet port to radio1 or radio2?

Thanks in advance and greetings from Germany

Titus

[Scott Fella]

My suggestion is to look around for examples by searching the following: Cisco Workgroup Bridge examples

This should help provide better context of how its used and maybe some gotchas.  I haven't used that in a very very long time, so I can't help much, but here is a few links:

WGB Config Example | mrn-cciew (mrncciew.com)

Access Point as a Workgroup Bridge Configuration Example - Cisco