Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

We have the Clio 1050(www.clio.com) and the NEC MobilePro 880. Using the Proxim RangeLAN cards(not 802.11b) the battery on these units lasts about 4 hours. Putting in the Cisco Aironet cards(340 or 350 series) battery is limited to about an hour. Any...

cardioworks by • Community Member
  • 1426 Views
  • 3 replies
  • 0 Helpful votes

I recently deployed some Catalyst 9130AXI access points on my Catalyst 9800 wireless controller. Under the radio statistics of the C9130 access points it is showing that spectrum analysis is disabled. What is that indicating? Does it mean that the ac...

Hello all.I have an issue where my internet got problem which is very slow connection when connecting to the Wi-fi. But when using ethernet, there is no problem at all.Any advice for me? 

takimy by • Community Member
  • 1440 Views
  • 7 replies
  • 0 Helpful votes

Dears,i have upgrade WLC IOS from Version 8.10.142.0 to version 8.10.181.0.now i need to upgrade Emergency Image Version from 8.5.103.0 to be the same Software Version 8.10.181.0.pls advisealso my Primary Image 8.10.181.0 and Backup Image 8.10.181.0 

Mobility Express and AireOs are legacy and it seems that they will disappear with the EoL of Cisco 802.11ac APThe option for small networks is to migrate to EWC.Mobility Express and AireOs were great for those small networks and were very easy to man...

jmprats by • Level 6
  • 4525 Views
  • 4 replies
  • 0 Helpful votes

Hi I have a 3504 & 5500 WLC,I have guset Wifi all set up. However, I am looking to set up a splash page for the Guest Wifi. I cannot find it anywhere?Our Guest authenticate via ISEAny help much appreciated

Hello Community! We have a highly secure environment with NAC on switchports. We need APs to use pre-provisioned(during staging) LSC certificates (same for DTLS encryption and AP Auth on the WLC) during 802.1x EAP-TLS authentication on the NAC switch...

Murinos by • Frequent Visitor
  • 7109 Views
  • 8 replies
  • 0 Helpful votes

Resolved! RMA AP

Need to RMA an access point. Please let me know what info you need.Thanks,

crepeauj by • Frequent Visitor
  • 4225 Views
  • 7 replies
  • 0 Helpful votes

Users try to access a distant AP without connecting to a nearby AP.We are looking for the reason.CleanAir was monitored.Interferer Type is Continuous TX. I think it's not WiFi.Duty Cycle is 100%.It looks like this might be the problem.What action is ...

IMG_0040 (1).jpg
Review Cisco Networking for a $25 gift card