cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
670
Views
0
Helpful
1
Replies
jacksonit
Beginner

Aironet 1231G - Missing "Channel" Command?

I have two Aironet 1231Gs, that are both running the same version of fimware: Version 12.3(8)JEE

From the gui, I try and change the channel on the main radio interface--It works from one, and I get just a blank page on the other.  When I try and change it via the cli, I use the "channel" command in conf int mode, and it works one the one, but the other one, the "channel" command doesnt exist.

What is going on?

1 REPLY 1
sudkulka
Cisco Employee

Can you send a "show version" and "show running-config" from both the AP1231s

Create
Recognize Your Peers
Content for Community-Ad