Wireless

Following the recent iOS 6 update, our company iPads with this version installed cannot be provisioned via our Cisco ISE Device provisioning portal.iPads running version 5 can be successfully provisioned, however version 6 iPads cannot.I do have a TA...

Hi Team,My customer need creats some separately web portal for some SSID (Guest and Staff), 01 web portal for Guest and 01 Web portal for Staff. Can WLC2504 can support this features ? Thanks & best Regards,Lam

Hi Experts,we are having more than 250 - AIR-LAP1131AG-N-K9 access point installed,We are facing issue in access point which SN is starting from FTX1216, its getting failed and not starting by PoE or power adaptor (dead)i analyzed all these failed ac...

hello, is there any device such as aruba rap-2

Hi there,I have just been setting up a WISM2 in a test lab and for some reason the Supervisor is not creating a port channel on my 6500 as suggested in the WISM2 Deployment Guide. WISM2 is installed in an appropriate slot (according to same doco) and...

Hello,I am trying to migrate from Cisco ACS to ISE.I want to log configuration commands entered on routers.I have configured the routers to send accounting radius to ISE but ISE sees the messages as:"22003  Missing attribute for authentication 11014 ...

So I bought a 2504 AP. I also have some AIR-CAP3602I-A-K9.The WLC web interface sees them in the CDP neighbors. The devices get an ip address but I can't add them as access points. I think if I can do that I can get something simple going.On the acce...

We're in the process of upgrading our wireless controllers and just doing a general clean up of our wireless envrionment. Currently we do MAC filtering through ACS with a built in database. The version of ACS is antiquated so we are looking for repla...

Hello,I have one question, I have wireless network with 45 APs, and I want to add some APs to use them in sniffer or monitor mode,would you please recommend, how many APs I need to sniff al the wireless network by design?Thanks in advanceBRTural L

Hello,I currently have a client that is searching for a solution to wireless connectivity issues. Nothing showing up to be a problem in NCS, site survey showed no dead areas in coverage. The device they are using to connect is too small to fit an int...

Hello, we have a couple of AP1262N-E-K9 APs with firmware version 12.4(25d)JA1 operating in autonmous mode. One AP is setup as repeater while all others are in root mode. My goal is to perform the antenna-alignment test through an SSH console on the ...