09-02-2014 07:05 PM - edited 07-05-2021 01:28 AM
Hi !
Please, can anybody confirm (or not) if the Cisco AP 2702 works in autonomous mode?
The documentation says that it works in standalone mode:
".. Controller-based deployment and standalone deployments."
But I can't find any setup for it, and even a real deployment without a WLC (maybe because it's a new product?).
Thanks in advance!
Regards.
Eduardo Piovesam
09-02-2014 08:45 PM
Hi Eduardo,
Yes this AP also work as Autonomous.
But Still cisco did not released the rght firmware for this.
**** As cisco says: 2700 is new, the autonomous IOS is for wireless site-survey only. It's not meant to service clients as of yet.
Regards
Dont forget to rate helpful posts
09-08-2014 06:55 AM
Hi Sandeep,
Do you know if the newest release (03-september) contains the "full autonomous mode"?
http://www.cisco.com/c/en/us/td/docs/wireless/access_point/ios/release/notes/rn-15-3-3.html
Thank you.
Eduardo Piovesam
09-08-2014 07:00 AM
Hi,
This is brnad new IOS:
I did not test this but I think this is full autonomus mode.
2700i:
http://software.cisco.com/download/release.html?mdfid=286256843&flowid=50363&softwareid=284180979&release=15.3.3-JAB&relind=AVAILABLE&rellifecycle=ED&reltype=latest
Regards
Dont forget to rate helpful posts
09-08-2014 02:34 PM
Hi Sandeep,
Could you please confirm if this image really supports the full autonomous mode in 2702e (maybe talking with someone at Cisco)?
Thank you!
Eduardo Piovesam
09-30-2014 02:15 PM
Does the autonomous 2702 code support 802.11ac or is it controller-based only?
09-30-2014 08:49 PM
Yes, this version is fully 802.11ac supported
ap3g2-k9w7-tar.153-3.JAB.tar
HTH
Rasika
**** Pls rate all useful responses ****
10-09-2014 03:32 PM
Just tried to convert a controller connected 2702e to autonomous mode with no success. I loaded the above mentioned image via the archive command but this ended up with the following error message on the controller:
AP with MAC: 7c:0e:ce:b9:49:80(AP1c6a.7abb.1d04) upgrade image from verion:8.0.100.0 to 8.0.72.236 failed. Failure Cause:Problem extracting image tar file or image is not a valid.
Any help would be really appreciated ...
rene
10-09-2014 04:09 PM
Try to use the mode button option described here & see if it end up similar fashion. Log the AP console output while doing this & attach it to see if that fails again.
http://mrncciew.com/2013/12/13/ap-conversion-using-mode-button/
HTH
Rasika
**** Pls rate all useful responses ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide