Wireless

Hi,   I am currently working on an Aironet SAP 1600 series (or a 2600 series). I use it as a sniffer by enabling the monitor frames command on one of my Dot11Radio interfaces. The endpoint is a PC that is running an HexaDump parser (Wireshark/Omnipee...

Hello, Following issue we have at one of our locations equipped with WLC 2504 (FW: AIR-CT2500-K9-8-0-133-0) & several AIR-CAP3602I-E-K9 During continuous client traffic load like SQL data retrieving, AP drop client. It mean client loose connection to...

Hi Alex, We have a setup with Cisco WLC 2504 and couple Cisco 1600 APs. Most of the clients (PC, Android, iPhone/iPad) are able to connect to the wireless. But, not with the Bosch soundtouch system. However, when soundtouch connect to my home wirele...

Dear Team ,  I have an issue where I have primary WLC 5508 have LPDE image installed and HA controller purchased with Non LPDE image installed. Due to this image mismatch , i am not able to configure HA and i need to inform the image installation in ...

Hello,we have an expected reboot of our active WLC5508 in HA cluster two weeks ago. The standby unit became active and because of Xmas and New Year holidays we found it only yesterday.There is no crash file generated by the controller during reboot. ...

I am facing issue with AP1532E joining to controller 2500. AP light flashing from green,red, yellow, green Below is the repeated log message. I have attached the full log from boot up to the repeating message. *Jun 27 10:30:34.000: %CAPWAP-5-DTLSRE...

Hello, we are looking to migrate our access points off an AD DHCP server over to Infoblox DHCP server.  We have dedicated subnets for the access points. The DHCP scopes will remain exactly the same between the two appliances. Any advice as to how to...

Hello Everyone I am trying to setup one Access Point in PI 2.2. Thia AP is installed at 16 feet from the floor but I can't configure it in more than 10 feet. Does anyone have the same problem or know how to fix it up? Thankls

Hi Dears, Do you know inform me what are the maximum number of simultaneous clients can be handled by the Cisco Aironet 1700 Series WAP? What are the number per radio? Thank for all! Allyson 

Hi, What are the best practices to be followed when we  allow byod's to use voice . How do we  restrict byod's using voice  . When often the voice calls drops , how do we analyze these drops in wireshark or omnipeek Thanks

I have 1 SSID, that is mapped to a group interface: GroupInterface01, which contains 2 dynamic interfaces: Data1: in VLAN-10 with default gateway: 10.10.10.1 Data2: in VLAN-20 with default gateway: 10.10.20.1 Sometimes the default gateway of either...

hi team facing below error on my WLC 2504. load profile updated to pass for base radio mac: XX:XX:XX:XX:XX:XX and slotNo: 0 can anyone let me that that what does it mean? regards, darshin 

Hi buddies, Because I want to broadcast different SSIDs on nearby APs, I need to use different AP groups. Is using two AP groups on nearby APs like creating tow domain of APs and ignoring all the good things that RRM algorithms gonna provide for netw...