05-15-2012 01:44 PM - edited 07-03-2021 10:10 PM
I have a newly purchased Aironet 3502i that I would like to configure on my network. I am new to Cisco networking in general, and would like to know how to configure the device to operate without a WLAN Controller.
Thanks!
05-15-2012 03:12 PM
For the time being there is no IOS image for this model of APs to operate without controller.
It can only work with WLC
-----------------------------------------------------------------------------------
Please Don't forget to rate correct answers
05-15-2012 03:15 PM
You can load the autonomous IOS of the 1260, HOWEVER, know the caveats:
1. Loading autonomous IOS into the 3500 is NOT SUPPORTED by Cisco TAC. If you have any configuration issues, for example, then you are on your own. TAC will support if you have a hardware issue.
2. CleanAir will NOT work with the autonomous IOS.
05-15-2012 03:35 PM
Now how would I go about loading this OS, generally speaking?
05-15-2012 09:34 PM
please check the following link:
--------------------------------------------------------------------
Please Don't Forget to rate correct answers
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide