06-18-2015 08:08 PM - edited 07-05-2021 03:26 AM
Can I convert Unified mode to Autonomous mode in the first boot time only?
I hope that I can convert in any boot time, if there is still no conversion.
And can I revert to Unified mode from autonomous image or lightweight image ?
In fact, is the "capwap ap autonomous" command one-time-only ?
Thank you.
Regards,
Atsushi
Solved! Go to Solution.
06-18-2015 08:23 PM
That command is indeed a one time command. Once the AP joins a controller or is setup as autonomous, the command will no longer be valid. The other methods of converting an access point will need to be used. Hope this helps.
-Scott
06-18-2015 08:23 PM
That command is indeed a one time command. Once the AP joins a controller or is setup as autonomous, the command will no longer be valid. The other methods of converting an access point will need to be used. Hope this helps.
-Scott
06-18-2015 08:34 PM
Hi Scott
I understand !
Thank you so much.
Regards,
Atsushi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide