cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2310
Views
6
Helpful
5
Replies

All APs lost PoE

Steve Simlo
Cisco Employee
Cisco Employee

I have a small home network.

MX64 / MS120 / 4 APs: MR33/20s - all in gateway mode

All APs have simultaneously lost PoE (no lights on any of them)
Switch is up and other wired ports are up

I just power cycled the MS that all of the MRs are homed to and one of the AP ports appears to have come up from the switch side but there is no status light on the AP in question

5 Replies 5

MerakiGnome
Meraki Community All-Star
Meraki Community All-Star

Hi @Steve Simlo , anything reported in the events log on your dashboard?

Darren OConnor
https://www.linkedin.com/in/darrenoconnor

Steve Simlo
Cisco Employee
Cisco Employee

bunch of DAI failures

been diagnosed as PoE controller failure in the MS

RMA on the way

MerakiGnome
Meraki Community All-Star
Meraki Community All-Star

Thank you for updating the post. I would mark your last post as Resolved as it’ll help others out in the future

Darren OConnor
https://www.linkedin.com/in/darrenoconnor

BlakeRichardson
Meraki Community All-Star
Meraki Community All-Star

Did you have any power outages or surges in the lead up to everything going offline?

If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.

Funny you should ask but yes....I was working on replacing some lights and at some point there was a short that tripped out a main breaker and I had to reset it

Honestly speaking that is not the first time we have had a short like that in the house and in the past the MS has handled it gracefully but not this time

Review Cisco Networking for a $25 gift card