any connect fail with ise

[k.elnokrashy1]

I have new system consist of
WLC 9800 L
AP9461ROW

I am trying  to integrate with ISE

the mobile device connect to ssid normally but PC with any connect fail to  connect
I traced the problem with the ISE admin and he replay that the PC with cisco any connect dose not get IP so it fails
dose the wirless device get its IP before connect successfully to the SSID ?
and why the mobile device connect with out any problem but PC with any connect could not connect

thanks a lot

[Mark Elsen]

                   >...does the wireless device get its IP before connect successfully to the SSID ?
         - No after , first check if the client is fully wireless connected and has obtained an IP address.

 M.

[k.elnokrashy1 · Accepted solution]

thanks  al lot the problem was that any connect ver not support wap3 
that cause miscommunication between ISE and AnyConnect the ISE administrator trace was wrong