Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1018
Views
0
Helpful
1
Replies

AP 1041 Conversion from Autonomous mode to Lightweight mode.

pankaj_cisco111
Beginner
Beginner

‎03-05-2012 05:05 AM - edited ‎07-03-2021 09:43 PM

We have recently converted 1 Cisco Lightweight AP 1041 to Autonomous mode for site-survey purposes. We now want to convert it back to lightweight mode. Is it possible?

Labels:
0 Helpful
1 Reply 1

Justin Kurynny
Enthusiast
Enthusiast

‎03-07-2012 05:32 PM

pankaj_cisco111,

Is the lightweight image still on flash? It should be unless you manually deleted it. If so, change the boot variable to point to the lightweight image:

1040ap(config)# boot system flash:/

/

Then write mem and reload. It should come up in lw mode.

Justin

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers
Spotlight Award Nomination
Customers Also Viewed These Support Documents