Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have recently converted 1 Cisco Lightweight AP 1041 to Autonomous mode for site-survey purposes. We now want to convert it back to lightweight mode. Is it possible?
Catalyst 6509 CPU utilization is continuously reaching 80-90% range. The process called ios-base is utilizing 70-80 % CPU. I shutdown all fiber and UTP interfaces and even upgraded switch IOS from s72033-adventerprisek9_wan-vz.122-18.SXF14.bin to s72...
There are set of 1131G access points which belong to different segment than management couldn’t be registered on Wireless Controller (Catalyst 6509 WISM). However access points allocated in same range of management network is easily registering on c...
I have Cisco 7921G phone which is not registering on WISM and displaying error ‘connection failed’. I have found the below error once activated the site-survey from Phone. The country code AE is not supported. (Country is UAE).
There are 8 Catalyst 3750 switches installed in stack. Switch1 to 6 and 8 are detecting in stack. However Switch 7 couldn’t be detected as stack member. However Switch 7 joins to stack membership once we remove switch 8 out of stack and create switch...
Hi Surendra,Problem still exists. It starts giving above error after creating separate dynamic interface for APs. Access-points join statistics simply disappear once I remove dynamic interface.Regards,Pankaj
Dear Puneet,Please find 'sh switch detail' 'and 'sh version' outputs below which taken from Master Switch in the stack. I had restarted all the switches including switch 8 to last in row. However it couldn't make any difference to Switch7. CAT3750-SW...
Dear Shivlu,Traffic gets easily shifted to RIP. However once OSPF comes up, RIP routes are still available in routing table. There is no OSPF reference cost bandwidth configured. Should I play with tag during redistribution? It might do the trick.Reg...
Router 1751 is not able to make outgoing call. That?s my main concern. Phone number is perfectly correct. It?s the same Phone no that dials Cisco 1751 & make successful data cal. So could you give any other suggestion Can it be IOS issue of 2620? Wai...
