Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Insider User Research program

Labels

Forum Posts

Client has multiple 1240AG's setup as access points throughout their factory.  They have a PC that they want to connect to the SSID and then be able to get to the Internet as well as the internal network.  The PC has no problem connecting to the SSID...

Hi,I have three questions about the 1260 APS. Can they run autonomously? Can I have them by PoE from the PoE ports on a  asa5505?Can I use 3, 2.4 dipole antennas and 3, 5.8 dipole antennas instead of the other external antennas that attach with the c...

I was wondering if someone could lists the benefits of putting APs in HREAP groups. Here is some detail about my network. I have 52 APs in one location. Some of these APs are 1140s and some are 3500s. This location has 9 floors with an average of 6 A...

Folks,         I have a requriement where the ACS server should send the vlan information based on SSID the user connected with.Can I do this in ACS 5.0. I know I have to write a policy. But can not find a fild for SSID.Any advice would be highly app...

Hello,We have recently purchased Cisco NCS Prime for our Cisco Wireless project. Before installation we need to confirm that NCSprime will be compatible with ESXi v5.0, as the release notes refer toESXi v4.0 and v4.1 only. http://www.cisco.com/en/US/...

Which device is good to capture wireless beacon frames.AirPcap or Linksys WUSB600N ver 1, ver 2 (Dual-band USB adapter)I want to check whether AP sending WME values or not.

Hi All,We currently tunnel guests to a 4402 that sits behind our firewall and it's been working well for a few years but I am aware that the 4402 is now EoL so I am exploring alternatives:We also have several 5508s deployed and I'm wondering if - in ...

Folks,          I have about 10 APs and 3 controllers and want to setup voice in my office. I went through the design guide, but I can not seem to find the things I need to do on the controller to make roaming work. Right know the phone calls and dro...

Resolved! WLC failover

I have 2 WLC, when i shut down the primary WLC, the 1231 AP didn't register to the backup WLC. All of the 1242 AP can register to the backup WLC. I wonder if the 1231 doesn't support the WLC failover.

cscyangyu by Level 1
  • 2385 Views
  • 5 replies
  • 0 Helpful votes

I would like to know if the 1040 AP have support to Band Select on controller-based mode, below there are two documents saying different things, Can anyone clarify this?AP At-a-glance - Says that bandselect is supported on 1040 for controller-based:h...

Hello, I'm having a problem with my clients dropping the network connection constantly throughout the campus. I am using a Cisco 5508 controller and the APs are LAP1141N.At first I thought it was a roaming issue but I tested with only 1 AP and the pr...

Review Cisco Networking for a $25 gift card