AP 1250 CLI command

[denis.roy]

What's the command to enable ssid's broad cast.

All I see is GUI examples in the doc's, but no cli examples.

[Scott Fella]

Under the SSID configure GUEST-MODE

Here is a link.. hope this helps.

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_10b_JA/configuration/guide/scg12410b-chap7-mbssid.html#wp1017196

[denis.roy]

I looked at it; I didn't see any cli commands to enable or disable broadcasting ssid's.

[Rob Huffman]

Hi Denis,

This command that Scott correctly noted does enable the SSID to be broadcast;

Step 6 guest-mode

(Optional) Designate the SSID as your access point's guest-mode SSID. The access point includes the SSID in its beacon and allows associations from client devices that do not specify an SSID.

Give it a try :) It doesn't mention broadcast but this is what it actually means.

Rob

[denis.roy]

you're right, it works. Who would of known it.

[Rob Huffman]

Hi Denis,

They couldn't just say something nice like "enable Broadcast ssid"

It's always something isn't it :)

Take care,

Rob