AP 1600 Configuration

[Bperry921]

Hello All, 

I'm having trouble resetting my wireless access point back to factory default settings.  I'm using AIR-CAP1602.  MAC OSX 10.10.3

Any help will be greatly appreciated.  

Thanks, Please let me know. 

[iteasyinformatica]

Hi Denniz,

thank you for your reply.

All AP are Aironet 1600 series.

What is the version of Mobility Express compatible with my AP?

Thanks.

[Denniz]

Sadly, the 1600 series is .11n and is not comaptible with Mobility Express, you will need a controller or a service contract to use the access points.

[JPavonM]

To use a Mobility Express solution with all your AP1600's you would need to buy an AP from model 1815/1830/1850/2800/3800/4800 and run AireOS 8.5 at maximum.

Check this release notes.

[iteasyinformatica]

Ok, thank you all.

if I turned the access points into standalone mode, could I configure them with VLANs?

Thanks again

[Scott Fella]

A contract is basically you paying for support.  This allows you access to the downloads.  From what the others already posted, you can't use the 1600 as a standalone, so if you don't have a controller, the ap is basically useless.

[Denniz]

Yes, you could use ssid to vlan mapping or EAP!