12-14-2020 02:15 PM - edited 07-05-2021 12:54 PM
Hi all, please can you help me?
i have a AP1852e, originally it was a lightwave ap (capwap) the model finish with K9,
I converted it in ME correctly, ( show version command displayed me the rows:
AP IMAGE TYPE: MOBILITY EXPRESS IMAGE
AP CONFIGURATION: MOBILITY EXPRESS CAPTABLE
Unfortunately i converted the AP with the last versione of ME image in the download software portal,
but the others AP in the customer network not has the last version of ME image but they have the version 8.8.100.0.
so i wanted downgrade the version from last versione ME to versione image 8.8.100.0. so I tried to reset the ap with the command:
AP#clear capwap ap all-config
if you need to reset AP to factory default (this command will cause system)
after restart the AP , I can not login it via SSH, only console outband. but when i connected it via console port, I displayed a wizard configuration, so i configured all fied requeriment and after the wizard configuration now the AP is a controller mode !
the prompt has this view:
(Cisco controller) >
I tried all options in this mode for return in capwap mode but no body options is correct.
how can i restart the AP with the capwap AP mode?
thanks so much.
12-14-2020 04:34 PM - edited 12-14-2020 04:36 PM
Enable
and try
#ap-type capwap ( it reboot)
also, refer :
12-15-2020 04:59 AM
Hi, in the pool of commands, ther are not command enable
(Cisco Controller) >enable
Incorrect usage. Use the '?' or <TAB> key to list commands.
(Cisco Controller) >
thanks
12-15-2020 07:11 AM
try below enable below see if that works :
AP Cisco Shell:
(Cisco Controller) > apciscoshell
> Enable
#ap-type capwap ( it reboot)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide