Hi,
We got many 2602 AP running under Controller mode. Every night Cisco Energywise turn the power off to these AP's and next morning turn it back on. But randomly in a month few AP fails to come back. When I check on console I see error - The system has encountered an error accessing flash during initializion. I re-inialize the flash using flash_init command and it boot's up perfectly without any problem.
AP Model - AIR-CAP2602I-Z-K9
AP Image - ap3g2-k9w8-tar.152-4.JB6
WLC SW Version - 7.6.130.0
Error Details:
IOS Bootloader - Starting system.
flash is writable
FLASH CHIP: Numonyx Mirrorbit (0089)
Xmodem file system is available.
Error accessing flash at 0xe8000000 with 32-bit reads [0xbfaaaaaa != 0xffaa6aaa]
The system has encountered an error accessing flash during initializion. The following commands will
initialize the flash file system and finish
loading the operating system software:
flash_init
ether_init
tftp_init
boot
ap: flash_init
Initializing Flash...
flashfs[0]: Checking block 0...bad block number (-21846)
flashfs[0]: erasing block 0...done.
flashfs[0]: 67 files, 9 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 31997952
flashfs[0]: Bytes used: 21580800
flashfs[0]: Bytes available: 10417152
flashfs[0]: flashfs fsck took 23 seconds.
...done Initializing Flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4
ap:
Any idea why this happens, 5-7 AP fails every month.
Regards,
Sakun
